1.斷續(xù)指入口最大壓力枢泰，連續(xù)工作壓力指工作壓差描融。
2.馬達不應同時在最高壓力和最高轉速下工作。
3.馬達在斷續(xù)工作條件下衡蚂，運行時間應不超過10%稼稿。
4.最高工作溫度80°。
5.馬達最高允許背壓10MPa讳窟，但建議使用背壓不要超過5MPa让歼，超過時應接外泄油管。
6.馬達滿負荷工作前丽啡，建議在最大工作壓力的40%以下磨合1小時谋右。
7.推薦用68#抗磨液壓油，粘度37-73cSt补箍，清潔度ISO18/13.
Note: 1. Intermittent means the entrance of the maximum pressure; continuous working pressure means the differential pressure
2. Motor should not work under the highest pressure and the maximum speed
3. The running time should not exceed 10% under intermittent working conditions
4. The Maximum working temperature is 80 °
5. The maximum allowable back pressure is 10MPa, but the recommended back pressure should not exceed 5MPa.a leaking pipes is needed when exceeding
6. one hour running time under 40% of maximum working pressure is recommended before full capacity working.
7. Recommending N68 anti-wear hydraulic oil, viscosity 37-73cSt, cleanliness ISO18/13.
